Differences

This shows you the differences between two versions of the page.

--- searchwing-wing-servo [2020/02/02 13:55] – [Wing servo connection] schrumpfschlauch 1,2 -> 1,6 beckmanf
+++ searchwing-wing-servo [2020/02/03 18:52] (current) – Shorten cable, reduce transparent shrinking tube to 20mm beckmanf
@@ Line 22: / Line 22: @@
 {{:sw-servo-m5-to-pixracer.jpg?600|Solder view}}
-  * Cut 25mm of the transparent shrinking tube and put it on the cable
+  * Shorten the servo cable by 40mm
+  * Cut 20mm of the transparent shrinking tube and put it on the cable
   * Separate the yellow, red and brown cable for about 5cm
-  * Add about 5mm of the 1.2mm shrinking tube to the red and the brown cable.
+  * Add about 5mm of the small shrinking tube to the red and the brown cable.
   * Move the shrinking tubes as far as possible from the solder spot to avoid accidental shrinking
   * Remove the isolation for about 4mm and twist and tin the wires.
@@ Line 48: / Line 49: @@
 The next image shows the small shrinking tubes moved over the solder connections.
-{{:sw-m5-shrinking-tube.jpg?600|Socket with 1.2mm shrinking tubes}}
+{{:sw-m5-shrinking-tube.jpg?600|Socket with shrinking tubes}}
   * Now shrink the black shrinking tubes with a heat gun. With the Heinel EL 1910 E heat gun select temperature "3" with maximum air speed.